MULTIFUNCTION GAUGE (LCD) (DPS MODEL ONLY)
Gauge Setup
Clock Setting
Once clock display as been selected,
use the display selector button to set
clock as follows:
vmo2011-008-001_a
1. Selector button
2. Time
1. Press and HOLD button (Display will
flash).
2. Choose the 12-hour (12H) or
24-hour (24H) format by pressing
button.
3. If the 12-hour format was selected,
choose Am ("A") or Pm ("P") by press-
ing button.
4. Press and HOLD button.
5. Choose hour first digit by pressing
button.
6. Press and HOLD button.
7. Choose hour second digit by press-
ing button.
8. Press and HOLD button.
9. Choose minutes first digit by press-
ing button.
10. Press and HOLD button.
11. Choose minutes second digit by
pressing button.
12. Press button to enter settings
(CLOCK will appear on display).
NOTE: The gauge will display the cur-
rent time for 10 seconds then will re-
turn to the normal display mode.
______________
60
Unit Selection (km/h vs MPH)
The speedometer, odometer and trip
meter are factory preset in miles but
it is possible to change them to kilo-
meter reading. Contact an authorized
Can-Am dealer.
Language Selection
The gauge display language can be
changed.
Refer to an authorized
Can-Am dealer for language availability
and setup the gauge to your prefer-
ence.