BRP can-am COMMANDER 2017 Series Operator's Manual page 60

MULTIFUNCTION GAUGE (LCD) (DPS MODEL ONLY)
vsi2009-018-033
Message Display Mode
Important messages can be displayed in the main screen. Refer to table below.
If an abnormal engine condition occurs, a message can be combined with a pilot
TROUBLESHOOTING
lamp. Refer to
MESSAGE
(NORMAL
OPERATION)
BRAKE
PERFORMANCE KEY
NORMAL KEY
WORK KEY
OVERRIDE
SEAT BELT
ENGINE LIMITATION
ENGAGED FASTEN
SEAT BELT
DPS MAX
DPS MED
DPS MIN
SPORT MODE ACTIVE
ECO MODE
MAINTENANCE
REQUIRED (1)
LOW GEAR
______________
58
section for details.
Message displayed when the brakes are applied continuously
for 15 seconds. (Speed needs to be higher than 5 km/h
(3 MPH))
Displayed at power up when the performance key is used.
Displayed at power up when the normal key is used.
Displayed at power up when the work key is used.
Override is displayed when the override switch is pressed and
the shift lever is set to reverse gear.
When the driver seat belt is not buckled and the vehicle speed
is less than 10 km/h (6 MPH), the message is displayed and
the pilot lamp will be lit. No engine torque limitation engaged.
When the driver seat belt is not buckled and the vehicle
speed is above 10 km/h (6 MPH), the message is displayed
and the pilot lamp stays on. The engine management will
engage a torque limitation that will limit the vehicle speed to
approximately 20 km/h (12 MPH).
Maximum steering assist.
Medium steering assist
Minimum steering assist.
Displayed when sport mode is activated.
Displayed when ECO mode is activated.
Displayed in gauge when vehicle is due for a maintenance.
Displayed when belt protection is active in high gear. (If
available and activated on your model)
DESCRIPTION