tmo2011-001-094_a
TYPICAL
1. Bleed screw
1000 Models
2. Unscrew bleed screws on thermo-
stat housing covers of both front
and rear cylinders.
tmo2011-001-501_a
1. Front cylinder bleed screw
tmo2011-001-502_a
1. Rear cylinder bleed screw
All Models
3. Remove the pressure cap.
4. Fill the cooling system until coolant
comes out of the bleed screw(s).
5. Install the bleed screw(s) using
NEW gasket rings and torque as
per following chart.
Gasket ring
6. Continue adding coolant until sys-
tem is full up to the pressure cap
seat in the refill adapter.
tmr2011-011-028_a
1. Cooling system refill adapter
2. Expansion tank hose
3. Coolant system full level (pressure cap seat)
7. Install pressure cap.
NOTICE
be carried out as specified to ensure
proper cooling system bleeding in
addition to the previous steps.
8. Lift the entire front end of the ve-
hicle so the front tires are 60 cm
(2 ft) above the ground for at least
1 minute.
______________
MAINTENANCE PROCEDURES
TORQUE
4.4 N•m to 5.6 N•m
(39 lbf•in to 50 lbf•in)
The following steps must
101