Figure 26 Mounting The Ap200 To A Suspended Ceiling Rail - Meru Networks AP150 Installation Manual

9. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
Caution!
mistakenly be plugged into the Console port.
Mounting Below a Suspended Ceiling
The optional suspended ceiling mounting kit allows the AP200 mounting bracket to
attach to suspended ceiling T-rails (see
Note:
to attach the AP200 to the mounting bracket.
Figure 26: Mounting the AP200 to a Suspended Ceiling Rail
To mount an AP200 below a suspended ceiling:
1. Determine the location on the ceiling rail where the AP will be mounted and
2. Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to
3. Adjust the distance between the caddy fasteners by using the mounting bracket
4. Tighten the caddy fasteners in place using a standard screwdriver. Do not
© 2007 Meru Networks, Inc.
connector, shown in Figure
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
To comply with NEC code, attach a grounding wire to any of the screws used
Keps nuts with attached
locking washer
remove the ceiling tiles.
the rail.
holes as a guide.
overtighten.
22.
Figure 26).
Suspended ceiling T-rail
Caddy fastener(s)
Plastic spacer(s)
Mounting bracket
Installing the Access Points
Installing the AP200 39