Figure 18 Mounting The Ap200 To A Suspended Ceiling Rail - Meru Networks AP100 Installation Manual

9. Connect the PoE 100BaseT Ethernet cable or 100BaseT Ethernet cable to the 100/1000 Ethernet
connector shown in Figure
Caution!
Be sure to connect the Ethernet cable to the Ethernet port; the cable can mistakenly be
plugged into the Console port.
10.
Optionally connect the external power source connector to the AP power inlet connector (shown
in Figure 14) and to the power source.
Mounting Below a Suspended Ceiling
The optional suspended ceiling mounting kit allows the AP200 mounting bracket to attach to
suspended ceiling T-rails (see
Note:
To comply with NEC code, attach a grounding wire to any of the screws used to attach the
AP200 to the mounting bracket.
Keps nuts with attached
locking washer
Figure 18: Mounting the AP200 to a Suspended Ceiling Rail
To mount an AP200 below a suspended ceiling:
1.
Determine the location on the ceiling rail where the AP will be mounted and remove the ceiling
tiles.
2.
Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to the rail.
3. Adjust the distance between the caddy fasteners by using the mounting bracket holes as a guide.
4.
Tighten the caddy fasteners in place using a standard screwdriver. Do not overtighten.
14.
Figure 18).
Suspended ceiling T-rail
Caddy fastener(s)
Plastic spacer(s)
Mounting bracket
Installing the Access Point
Installing the AP200 27