Figure 10 Mounting The Ap200 To A Suspended Ceiling Rail - Meru Networks ap150 Installation Manual

9. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet connector, shown
in Figure 6.
Caution!
Be sure to connect the Ethernet cable to the Ethernet port; the cable can mistakenly be
plugged into the Console port.
Mounting Below a Suspended Ceiling
The optional suspended ceiling mounting kit allows the AP200 mounting bracket to attach to
suspended ceiling T-rails (see
Note: To comply with NEC code, attach a grounding wire to any of the screws used to attach the
AP200 to the mounting bracket.
Keps nuts with attached
locking washer
Figure 10: Mounting the AP200 to a Suspended Ceiling Rail
To mount an AP200 below a suspended ceiling:
1. Determine the location on the ceiling rail where the AP will be mounted and remove the ceiling
tiles.
2. Place each of the two caddy fasteners on the ceiling T-rail and twist to attach to the rail.
3.
Adjust the distance between the caddy fasteners by using the mounting bracket holes as a guide.
4. Tighten the caddy fasteners in place using a standard screwdriver. Do not overtighten.
5.
Place each spacer on the caddy fastener stud. The spacer legs should contact the ceiling
T-rail.
6. Align the mounting bracket keyholes with the caddy fastener studs and slide the AP200 to the
narrow end of the hole.
Figure 10).
Suspended ceiling T-rail
Caddy fastener(s)
Plastic spacer(s)
Mounting bracket
Installing the Access Point
Installing the AP200 15