Figure 21 Ap200 Antenna Connection; Figure 22 Ap200 Connector Panel - Meru Networks AP150 Installation Manual

Installing the Access Points
Horizontal Mounting
To horizontally mount an AP200:
1. Place the AP200 flat on the horizontal surface.
2. For each antenna, loosen the knurled ring at the base of the antenna (see
Antenna
Figure 21: AP200 Antenna Connection
3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
Caution!
mistakenly be plugged into the Console port.
Figure 22: AP200 Connector Panel
36 Meru Access Point and Radio Switch Installation Guide
Figure 21), point the antenna straight up, then retighten the ring.
Turn clockwise
to tighten
connector, shown in Figure
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
(Reserved)
Console
Antenna 1
port
CONSOLE
ANT 1
22.
Reset
100/1000
(Push to restore
Ethernet
default settings)
ETHERNET
(Currently
unsupported)
Power Antenna 2
inlet
3.3 VDC
ANT 2
© 2007 Meru Networks, Inc.