Mounting The Access Point; Figure 13 Ap200 Antenna Connection - Meru Networks AP100 Installation Manual

Caution!
before moving the antenna. Retighten the ring afterward. Otherwise, you might damage the internal
cabling in the AP.

Mounting the Access Point

You can mount an AP200 in the following ways:
Horizontally, as described in the
Vertically, as described in the
Below a hanging ceiling, as described in the
Above a tiled hanging ceiling, as described in the
section.
Horizontal Mounting
To horizontally mount an AP200:
1.
2.
Access Point 200
Antenna
Figure 13: AP200 Antenna Connection
3.
Caution!
plugged into the Console port.
When changing the orientation of the antennas, be sure to slightly loosen the knurled ring
Place the AP200 flat on the horizontal surface.
For each antenna, loosen the knurled ring at the base of the antenna (see
antenna straight up, then retighten the ring.
Turn clockwise
to tighten
Connect the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet connector, shown in
Figure 14.
Be sure to connect the Ethernet cable to the Ethernet port; the cable can mistakenly be
"Horizontal Mounting"
"Vertical Mounting" section.
"Mounting Below a Suspended Ceiling"
"Mounting Above a Suspended Ceiling"
Installing the Access Point
section.
Figure 13), point the
Installing the AP200
section.
23