Honeywell Voyager 1450g Series Quick Start Manual

Honeywell Voyager 1450g Series Quick Start Manual

Hide thumbs Also See for Voyager 1450g Series:


Voyager™ 1450g Series
Corded Area-Imaging Scanner

Quick Start Guide

Aller à
Vai a
Gehe zu
Ir a
Para Português, acesse
Перейти на русскоязычный сайт
Pro češtinu jdi na
Pre slovenčinu choď na
日本語 :
如要到中国简体) 。
pour le français.
per l'italiano.
für Deutsch.
para español.
로 이동합니다 .
VG1450-QS Rev A


Table of Contents

Summary of Contents for Honeywell Voyager 1450g Series

  • Page 1: Quick Start Guide

    Voyager™ 1450g Series Corded Area-Imaging Scanner Quick Start Guide Aller à pour le français. Vai a per l'italiano. Gehe zu für Deutsch. Ir a para español. Para Português, acesse Перейти на русскоязычный сайт Pro češtinu jdi na Pre slovenčinu choď...
  • Page 2: Getting Started

    Note: Refer to your user’s guide for information about cleaning your device. For localized language versions of this document, go to Getting Started Turn off computer’s power before connecting the scanner, then power up the computer once the scanner is fully connected.
  • Page 3 Power Supply Assembly (if included) Connecting the Scanner USB:...
  • Page 4 Keyboard Wedge: RS232 Serial Port:...
  • Page 5: Reading Techniques

    RS485: Reading Techniques The view finder projects an aiming beam that should be centered over the bar code, but it can be positioned in any direction for a good read. Hold the scanner over the bar code, press the button, and center the aiming beam on the bar code.
  • Page 6: Standard Product Defaults

    If the bar code is highly reflective (e.g., laminated), you may need to tilt the scanner at an angle so the bar code can be scanned. Standard Product Defaults The following bar code resets all standard product default settings. Standard Product Defaults Note: PDF and 2D bar codes can only be read by Voyager model 1450g2D and cannot be read by model 1450g1D.
  • Page 7: Keyboard Country

    Keyboard Country Scan the Program Keyboard Country bar code below, then scan the numeric bar code(s) from page 11, then the Save bar code to program the keyboard for your country. As a general rule, the following characters are not supported by the scanner for countries other than the United States:...
  • Page 8 Trigger The following bar codes will allow you to use the scanner in Manual Trigger - Normal Mode (need to press the button to read) or Presentation mode (the scanner is activated when it “sees” a bar code). Manual Trigger - Normal (Default) Presentation Mode Suffix...
  • Page 9: Add Code Id Prefix To All Symbologies

    Add Code ID Prefix to all Symbologies Scan the following bar code if you wish to add a Code ID prefix to all symbologies at once. Add Code ID Prefix To All Symbologies (Temporary) Note: For a complete list of Code IDs, see the User’s Guide for your product at our website,
  • Page 10: Data Format Editor Instructions

    Data Format Editor Instructions The following are abbreviated instructions for entering a data format. For complete instructions refer to your User’s Guide, available at our website, 1. Scan the Enter Data Format symbol. 2. Primary/Alternate Format: scan 0 for Primary Format 3.
  • Page 11: Programming Chart

    Programming Chart...
  • Page 12 Save...
  • Page 13: Technical Assistance

    For localized versions of this document, and to download the User’s Guide, go to Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.

Table of Contents