Power Save Modes - Honeywell MS2421 Installation And User Manual

Power Save Modes

The MS2421/MS2422/MS2431 bar code scanners have five configurable power save modes. Refer to the
MetroSelect Configuration Guide for additional information on Power Save Modes.
1. Blink Power Save Mode:
Blinks the laser OFF & ON after a configured period of non-use.
When the scanner recognizes a bar code it will exit the Blink mode.
2. Laser Off Power Save Mode:
Turns the laser OFF after a configured period of non-use. The motor continues to spin allowing for a faster
"wake" up time.
Any movement detected by the photocell will "wake" the scanner from the Laser Off power save mode
(see Figure 31 on page 33).
3. Laser & Motor Off Power Save Mode:
Turns the laser and motor OFF after a configured period of non-use.
Any movement detected by the photocell will "wake" the scanner from the power save mode (see Figure 31
on page 33). This mode's "wake" time is slightly longer due to the motor's need to restart.
4. Dual Action Power Save Mode #1:
"Blinks" the laser OFF & ON after a configured period of non-use turns the laser and motor OFF at thirty-
minute intervals.
Example:
If the power save timeout is set to 15 minutes.
Any movement detected by the photocell will "wake" the scanner from the power save mode (see Figure 31
on page 33).
5. Dual Action Power Save Mode #2 (Default):
Turns the laser OFF after a configured period of non-use then turns the motor OFF after thirty-minute
intervals.
Example:
If the power save timeout is set to 15 minutes.
Any movement detected by the photocell will "wake" the scanner from the power save mode (see Figure 31
on page 33).
41