Cable Information; Camera Link Cable; Power Cable - Basler L800k User Manual

2.2 Cable Information

2.2.1 Camera Link Cable

A Camera Link compatible MDR cable assembly is available from Basler as a stock item (part #
1000013041 for a 3 meter cable and part # 1000013042 for a 5 meter cable). As an alternate, you
can use the cable assembly manufactured by 3M (part # 14X26-SZLB-XXX-0LC).
The maximum allowed length for the MDR cable used with an L800
Note that in order to access the Integrate Enabled signal, you must use the Basler
stock cable (see Sect. 2.5.6).

2.2.2 Power Cable

A Hirose, 6-pin locking plug will be shipped with each camera. This plug should be used to connect
the power supply cable to the camera.
For proper EMI protection, the power supply cable attached to this plug must be a twin-cored,
shielded cable. Also, the housing of the Hirose plug must be connected to the cable shield and
the cable must be connected to earth ground at the power supply.
Power requirements are given in Section 2.8.
BASLER L800
k
Draft
Camera Interface
is 10 meters.
k
2-5