Area Of Interest Length Csr - Basler L800k User Manual

Area of Interest Length CSR

Register Base Address: 0x100A
Field Name: Register Status
Description: The integer value in this field indicates the status of this control register:
Field Name: Length
Description: Writing an integer value to this field sets the length in pixels for the area of interest (AOI)
Field Name: Min
Description: Minimum allowed integer value for the length setting. This field is updated to reflect limita-
Field Name: Max
Description: Maximum allowed integer value for the length setting. This field is updated to reflect limita-
Field Name: Increment
Description: An integer value indicating the increment for the length setting.
BASLER L800
k
0x00 = The register is not available
0x01 = The register is available. All related settings are OK
0x80 = A value in the register is set out of range
0X81 = The setting for the AOI length conflicts with the setting for the AOI starting pixel.
feature. The value for the length in pixels can normally range from 2 (0x0001) to 8160
(0x1FE0). The actual available range may be limited by the way any related parameters
are set.
If the value is set to 2, the length of the AOI will be 2 pixel. If the value is set to 4, the length
of the AOI will be 4 pixels. Etc.
(The AOI Length must be set to an even number, i.e., 2, 4, 6, 8, etc.)
The 2 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the length value
Byte 2 = High byte of the length value
See Section 3.7 for more information about the AOI feature.
tions caused by the way any related features are set.
The 2 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the min value
Byte 2 = High byte of the min value
tions caused by the way any related features are set.
The 2 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the max value
Byte 2 = High byte of the max value
The 4 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the max value
Byte 2 = High byte of the max value
Draft
Offset: 0x0000
Offset: 0x0001
Offset: 0x0003
Offset: 0x0005
Offset: 0x0007
Configuring the Camera
Size: 1 Byte Type: Read only
Size: 2 Bytes Type: Read / Write
Size: 2 Bytes Type: Read only
Size: 2 Bytes Type: Read only
Size: 2 Bytes Type: Read only
4-35