Binary Command Protocol Status Inquiry - Basler L800k User Manual

Binary Command Protocol Status Inquiry

The camera has been programmed to detect several errors in the format of any binary commands received
by the camera. When an error condition is detected, a flag is set. The binary command status inquiry register
allows you to read the error flags.
Register Base Address: 0x0C30
Field Name: Register Status
Description: The integer value in this field indicates the status of this inquiry register:
Field Name: Binary Command Status
Description: Each bit in this field specifies an error condition (see table below). Bit 0 is the least signifi-
BASLER L800
k
0x00 = The register is not available
0x01 = The register is available.
cant bit. If a bit is set to 1, the error condition assigned to that bit is present. If the bit is set
to 0, the error is not present.
Bit Description
0 A binary command with no BFS was received (see Section 4.3.1).
1 A byte time-out has occurred (see Section 4.3.1.1).
2 A binary command with an invalid OpCode was received (see Section 4.3.1).
3 A binary command with no BFE was received (see Section 4.3.1).
4 A binary command with an incorrect BCC was received (see Section 4.3.1).
5 A binary command with an address error was received (see Section 4.3.1).
6 Reserved
7 An unknown error has occurred.
Draft
Offset: 0x0000
Offset: 0x0001
Configuring the Camera
Size: 1 Byte Type: Read only
Size: 1 Byte Type: Read only
4-11