Pin Assignment For The Vga Monitor Output (A504K/Kc Only); Cable Information; Camera Link Cable - Basler WOOD BURNING FIREPLACE Wood Burning Fireplace

2.1.5 Pin Assignment for the VGA Monitor Output
(A504k/kc Only)
The 15 pin HDSub receptacle for the VGA monitor output transmits 640 x 480 pixels at a rate of
60 fps.
Pin
Number
1
2
3
4, 9
5, 6, 7, 8,
10, 11
12
13
14
15
Table 2-5: A504

2.2 Cable Information

2.2.1 Camera Link Cable

The Camera Link specification requires the use of a standard MDR cable assembly manufactured
™
by 3M (part # 14X26-SZLB-XXX-0LC).
The maximum recommended allowed length for the MDR cable used with an A501
The maximum recommended allowed length for the MDR cable used with an A503
is 5 meters.
A504
k/kc
A Camera Link compatible MDR cable assembly is available from Basler as a stock item (part #
1000013905 for a 3 meter cable and part # 1000013906 for a 5 meter cable). Alternatively, you
can use the cable assembly manufactured by 3M (part # 14X26-SZLB-XXX-0LC). The A501
can also use a base configuration Camera Link cable. See the cable information on the Basler
website www.basler-vc.com.
The maximum cable length will decrease when used in an area with severe ambient
electromagnetic interference.
Basler A500
k
PRELIMINARY
Signal
Direction
Name
Red Video Output
Green Video Output
Blue Video Output
not connected
DC GND Output
not connected
HSync Output
VSync Output
not connected
Pin Assignments for the VGA Monitor Output
k/kc
Function
Red Video
Green Video
Blue Video
DC Ground
SDA is not supported
HSync, 5 V TTL signal
VSync, 5 V TTL signal
SCL is not supported
Camera Interface
is 7 meters.
k/kc
or
k/kc
k/kc
2-7