Left Odd/Even Offset Balance Csr - Basler L800k User Manual

Configuring the Camera

Left Odd/Even Offset Balance CSR

Note: The left odd/even offset balance can be set by writing a floating point value to the Absolute
L O/E Offset Balance field or by writing an integer value to the Raw L O/E Offset Balance field.
Refer to Section
Register Base Address: 0x0F40
Field Name: Register Status
Description: The integer value in this field indicates the status of this control register:
Field Name: Absolute L O/E Offset Balance
Description: Writing a floating point value to this field sets the left odd/even offset balance in DN (digital
Field Name: Absolute Min
Description: Minimum allowed floating point value for the absolute left odd/even offset balance setting.
Field Name: Absolute Max
Description: Maximum allowed floating point value for the absolute left odd/even offset balance setting.
Field Name: Raw L O/E Offset Balance
Description: Writing an integer value to this field sets the left odd/even offset balance.
4-30
4.2.2.1 for an explanation of the difference between these two fields.
0x00 = The register is not available
0x01 = The register is available. All related settings are OK
0x80 = A value in the register is set out of range
numbers). For example, if the value in this field is set to +10.5, the left odd/even offset bal-
ance would be +10.5 DN.
When the camera is set for 8 bit output, the left odd/even offset balance can normally range
from -20.0 DN to +20 DN in increments of 0.5.
When the camera is set for 10 bit output, the left odd/even offset balance can normally
range from -80.0 DN to +80 DN in increments of 0.5.
The value in this field is a standard IEEE-754 single precision (32 bit) floating point number.
See Section 3.6.4 for more information about offset balance.
The value in this field is a standard IEEE-754 single precision (32 bit) floating point number.
The value in this field is a standard IEEE-754 single precision (32 bit) floating point number.
The value can normally range from -40 (0XFFD8) to +40 (0X0028).
The DN of left odd/even offset balance that will be applied at a given setting in this field is
determined by this formula:
DN = setting / 2
For example, if the value in this field is set to +15 (0x000F), then:
DN = 15 / 2
DN = 7.5
The 2 bytes in this field are interpreted as follows:
Byte 1 = Low byte of the raw value
Byte 2 = High byte of the raw value
See Section 3.6.4 for more information about offset balance.
Draft
Offset: 0x0000
Offset: 0x0001
Offset: 0x0005
Offset: 0x0009
Offset: 0x000D
Size: 1 Byte Type: Read only
Size: 4 Bytes Type: Read / Write
Size: 4 Bytes Type: Read only
Size: 4 Bytes Type: Read only
Size: 2 Bytes Type: Read / Write
BASLER L800
k