Video Data Output Modes; Setting The Video Data Output Mode; Changes To The Maximum Line Rate - Basler L800k User Manual

3.3 Video Data Output Modes

cameras can output video data in six different modes:
L800
k
• Single 8 bit mode
• Single 10 bit mode
• Dual 8 bit mode
• Dual 10 bit mode
• Dual separated 8 bit mode
• Dual separated 10 bit mode
These modes of operation are described in detail in Section 2.5.5.

3.3.1 Setting the Video Data Output Mode

You can set the video data output mode with the Camera Configuration Tool Plus (CCT+) or by
using binary write commands from within your own application to set the camera's control and
status registers (CSRs).
With the CCT+
With the CCT+ (see Section 4.1), you use the Video Data Output Mode parameter in the Output
Mode parameters group to set the output mode.
By Setting CSRs
You select the video data output mode by writing a value to the Mode field of the Video Data
Output Mode CSR (see page 4-17).
See Section 4.2.2
write commands.

3.3.2 Changes to the Maximum Line Rate

The video data output mode has an effect on the camera's maximum achievable line rate.
See Sections
BASLER L800
k
for an explanation of CSRs and Section
3.4.1.3 and 3.4.2.3.
Draft
4.3.1
Operation and Features
for an explanation of using read/
3-3