Changes To The Maximum Line Rate; Enabling/Disabling Two-Line Averaging - Basler L800k User Manual

Draft
Operation and Features

3.9.4.2 Changes to the Maximum Line Rate

Use of the two-line averaging feature has an effect on the camera's maximum achievable line rate.
See Section 3.4.

3.9.4.3 Enabling/Disabling Two-line Averaging

You can enable or disable two-line averaging with the Camera Configuration Tool Plus (CCT+) or
by using binary write commands from within your own application to set the camera's control and
status registers (CSRs).
With the CCT+
With the CCT+ (see Section 4.1), you use the Two-line Averaging parameter in the Image
Enhancement parameters group to enable or disable two-line averaging.
By Setting CSRs
You enable or disable two-line averaging by writing a value to the Mode field of the Two-line
Averaging CSR (see page 4-41).
Section 4.2.2 explains CSRs. Section 4.3.1 explains using read/write commands.
BASLER L800
3-35
k