Motion Control Assembly Replacement - Toro TITAN Max Service Manual

Park Brake Handle Assembly Installation

Motion Control Assembly Replacement

Motion Control Assembly Removal
TITAN® Max Service Manual
3442-428 Rev A
1. Connect the upper brake linkage to the brake shaft.
2. With the park brake handle hardware orientated as shown, install the
(0.375-16 x 1.500 inch) screw and (3/8-16 inch) flange nut.
3. With the park brake shaft in disengaged position and the park brake lever in
the lower position, rotate the upper brake linkage until the end aligns with the
hole in the park brake lever.
4. Secure with a locking cotter pin.
5. Cycle the park brake lever to ensure that it locks in the engaged position.
6. Install the left console.
7. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
8. Verify the proper function of the unit.
1. Park the machine on a level surface and disengage the PTO. Stop the engine,
wait for all moving parts to stop, and remove key. Engage the parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the left and right consoles.
Right Console Removal (page 5–16)
4. Raise and support the unit so that the front wheels are off the ground, block
rear wheels.
5. Remove the 2 (3/8-16 X 1.00 inch) screws securing the motion control handle
to the motion control assembly.
6. Remove the (5/16-18 inch) shoulder screw securing the motion control
damper from the motion control assembly.
7. Disconnect the motion control linkage from the transmission.
g336043
8. Disconnect the motion control assembly from the frame.
Left Console Removal (page 5–13)
Left Console Removal (page 5–13)
Figure 60
Page 5–31 Chassis: Service and Repairs