Toro TITAN Max Service Manual page 45

Caster Assembly and Bearing Removal (continued)
Caster Assembly and Bearing Installation
TITAN® Max Service Manual
3442-428 Rev A
g342956
8. Inspect the 2 bearings for wear or damage. Replace if necessary.
9. Inspect the inside of the axle bearing area for damage or excessive wear.
1. Clean the surface inside the axle bearing area, keeping surface clean of
debris.
2. Using a (32 mm) socket and a hammer, install the lower bearing from the
bottom side into the axle. Verify the bearing is fully seated.
Note: The bearings are sealed and do not require grease/lubrication.
3. Using a (32 mm) socket and a hammer, install the upper bearing from the
bottom side into the axle. Verify the bearing is fully seated.
Note: The bearings are sealed and do not require grease/lubrication.
Figure 21
Page 5–9 Chassis: Service and Repairs