Toro TITAN Max Service Manual page 69

Motion Control Assembly Installation (continued)
TITAN® Max Service Manual
3442-428 Rev A
g336043
5. Adjust the nut on the motion control assembly until the motion control nut
is centered in the control plate slot.
6. Install the motion control damper to the motion control assembly, secure
with a (5/16-18 inch) shoulder screw. Torque the screw to 9.039–11.298
N • m (80-100 in-lb).
7. Install the motion control handle to the motion control assembly, secure with
2 (3/8-16 X 1.00 inch) screws. Torque the screw to 40.67 ± 4.07 N • m (30 ±
3 ft-lb).
8. Adjust the motion control linkages. See the product Operator's Manual for
the motion control linkage adjusting procedure.
9. Lower the unit to the floor.
10. Install the left and right consoles.
Console Installation (page 5–18)
11. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
12. Verify the proper function of the unit.
13. Adjust the tracking if necessary. See the product Operator's Manual for the
tracking adjustment procedure.
Figure 63
Left Console Installation (page 5–15) Right
Page 5–33 Chassis: Service and Repairs