Toro TITAN Max Service Manual page 99

Hydrostatic Drive Transmission Installation (continued)
TITAN® Max Service Manual
3442-428 Rev A
3. Install the 2 (0.312-18 x 2.250 inch) front and 2 (5/16-18 x 4.75 inch) rear
hydro mounting screws, washers, and (5/16-18 inch) nuts. Do not tighten
at this time.
4. Torque the cross shaft screw to 61 ± 6.779 N • m (43 ± 5 ft-lb).
5. Tighten the rear hydro mounting screw.
6. Tighten the 2 axle horn screw.
7. Tighten the front hydro mounting screw.
8. Remove the protective cap from the hydraulic oil nipple (if installing a new
hydrostatic drive). Install the hydraulic fluid hose, and move the hose clamp
into place.
9. Connect the lower brake linkage to the transmission.
10. Connect the bypass arm.
11. Connect the motion control linkage.
Note: Attach the motion control linkage as shown with the offset toward
the outside of the machine.
g336199
12. Install the hydrostatic drive belt onto the machine.
Installation (page 7–8)
13. Install the deck drive belt onto the mower deck.
(page 6–12)
14. Verify that the (3/4-16 inch) hub nut is torqued to 325.4-352.5 N • m (240–260
lb-ft).
15. Install the drive wheel and torque the lug nuts. Torque the nuts to 122–135.58
N • m (90–100 ft-lb).
16. Add hydraulic oil to the reservoir to the FULL COLD line.
17. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 105
Page 7–7 Hydrostatic Drive System: Service and Repairs
Hydrostatic Drive Belt
Deck Drive Belt Installation