Toro TITAN Max Service Manual page 32

Engine Removal (continued)
Engine Installation
Engine: Service and Repairs
g349637
12. Disconnect the throttle cable.
13. Disconnect the choke cable.
14. Disconnect the clutch wire from the clutch.
15. Remove the (7/16 x 3 inch) clutch mounting screw and 2 washers. Slip the
clutch off of the crankshaft.
Note: Before removing the clutch, note the orientation of the clutch wire
and the clutch.
16. Remove the engine pulley. Retain the square key securing the pulley to
the crankshaft.
17. Remove the 4 (0.375-16 x 1.500 inch) engine mounting screws.
Note: Before removing the engine mounting screws, note the orientation of
the clutch anchor. The clutch wire can remain attached to the clutch anchor.
18. Remove the engine from the frame.
1. Prepare the frame and secure any fuel lines or wire harness components.
2. Install the engine onto the frame.
3. Align the 4 holes of the engine base to the frame and attach the 2 (0.375-16
x 1.500 inch) rear mounting screws and belleville washers loosely.
4. Attach the front 2 screws and belleville washers through the clutch anchor
and into the engine base.
5. Torque the 4 screws to 36.6–44.7 N • m (27–33 ft-lb).
6. Install the key and engine pulley onto the crankshaft.
Note: Install the engine pulley with the larger diameter hub toward the engine.
7. Install the clutch onto the crankshaft ensuring that the slot in the clutch aligns
with the tab on the clutch anchor.
8. Install the 2 spring washers and the (7/16 x 3 inch) clutch screw. Torque the
screw to 66.4–82.7 N • m (49-61 ft-lb).
Figure 8
Throttle Cable Assembly Removal (page 5–26)
Choke Control Assembly Removal (page 5–29)
Page 4–6 TITAN® Max Service Manual
3442-428 Rev A