Toro TITAN Max Service Manual page 61

Roll Over Protection System (ROPS) Removal (continued)
Roll Over Protection System (ROPS) Installation
TITAN® Max Service Manual
3442-428 Rev A
Note: For easier access, remove the left and right side consoles.
Console Removal (page 5–13) Right Console Removal (page 5–16)
4. Support the ROPS assembly and remove the 2 screws, 4 washers, and 2
nuts securing the LH ROPS assembly to the chassis. Repeat on the RH
ROPS assembly.
g344235
5. Lift and remove the ROPS assembly from the machine.
1. Install the ROPS assembly onto the machine.
2. Install the 2 screws, 4 washers, and 4 nuts securing the LH ROPS assembly
to the chassis. Repeat on the RH ROPS assembly.
Note: The orientation of the ROPS hardware is critical. Verify the screws
are orientated correctly.
g344235
Figure 51
Figure 52
Page 5–25
Left
Chassis: Service and Repairs