Toro TITAN Max Service Manual page 89

Belt Tensioner Removal (continued)
Belt Tensioner Installation
TITAN® Max Service Manual
3442-428 Rev A
g344578
7. Remove the 2 washers, 6 friction washers, and spacer from the mower deck.
g344580
1. Screw
2. Washer
3. Friction Washer
8. Remove the idler arm from the mower deck.
9. Inspect the 6 friction washers for damage. Replace if necessary.
1. Install the (0.375-16 x 2.5 inch) screw into the underside of the idler arm.
Verify the screw is on the correct side of the idler arm.
2. Install the idler bushing, idler pulley, washer, idler belt guide, and nut onto
the idler arm.
Figure 94
Figure 95
4. Lift Lever Bushing
5. Idler Arm
6. Washer
Page 6–19 Mower Deck: Service and Repairs