Toro TITAN Max Service Manual page 114

Electric PTO Clutch Installation (continued)
Electric PTO Clutch-Coil Resistance Measurement Test
Electrical System: Service and Repairs
g344399
5. Install the floor pan onto the machine.
g344398
6. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
7. Verify the proper function of the machine.
If the PTO clutch is not engaging or is suspect as a cause of electrical problems,
use the following electrical troubleshooting steps. These procedures will help
determine if the clutch has failed as a result of or is the cause of an electrical
problem.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the clutch wire connector.
3. Set the multi-meter to measure resistance (OHMs setting).
4. Connect the meter lead wires to the terminals in the clutch connector.
Figure 124
Figure 125
Page 8–14 TITAN® Max Service Manual
3442-428 Rev A