Toro TITAN Max Service Manual page 64

Throttle Cable Assembly Installation (continued)
Chassis: Service and Repairs
g336055
4. Install the throttle cable from the throttle plate.
5. Move the throttle control lever to the slow idle position.
6. Place the z-bend of the throttle cable in the throttle plate on the engine in
the position previously noted.
7. Place the cable under the cable clamp.
8. Tighten the clamp securing the throttle cable to the throttle plate.
g344236
9. Install the 4 (5/16-18 x 2 3/4 inch) torx screws, 4 (5/16-18 inch) nuts, 2
(0.312-18 x 1.000 inch) carriage screws, and 2 (5/16-18 inch) nuts securing
the rear guard to the mainframe. Torque all fasteners to 24.29 ± 3.95 N
• m (215 ± 35 in-lb).
10. Install the 2 (10-24 x 1/2 inch) screws and 2 (10-24 inch) nuts securing the
throttle cable assembly to the control panel assembly.
11. Install the control panel assembly onto the right console.
Installation (page 5–18)
12. Ensure that the throttle control lever is in the slow idle position and tighten
the cable clamp.
Figure 56
Figure 57
Page 5–28
Right Console
TITAN® Max Service Manual
3442-428 Rev A