Toro TITAN Max Service Manual page 63

Throttle Cable Assembly Removal (continued)
Throttle Cable Assembly Installation
TITAN® Max Service Manual
3442-428 Rev A
g344236
8. Remove the throttle cable from the throttle plate, noting the position of the
cable in the plate.
9. Pull the throttle cable assembly through the console and out of the machine.
1. Route the throttle cable through the right console between the ROPS and
the hydraulic fluid reservoir, under the fuel and vent lines, and under the
electrical.
g336057
2. Attach the throttle cable assembly to the control panel assembly using 2
screws and nuts.
3. Install the knob on the throttle lever.
Figure 54
Figure 55
Page 5–27 Chassis: Service and Repairs