Toro TITAN Max Service Manual page 98

Hydrostatic Drive Transmission Removal (continued)
Hydrostatic Drive Transmission Installation
Hydrostatic Drive System: Service and Repairs
11. Remove the (0.375-16 x 2.00 inch) screw that connects the transmission to
the cross shaft.
12. Remove the 2 (0.312-18 x 2.250 inch) front hydro mounting screws and
2 (5/16-18 inch) nuts.
13. Remove the 2 (5/16-18 x 4.75 inch) rear hydro mounting screws and 2
(5/16-18 inch) nuts.
g336195
1. Front and Rear Mounting Screws
2. Cross Shaft
14. Support the transmission, loosen and remove the 2 (5/16-18 inch) axle horn
nuts, washers, and 2 (5/16-18 x 3.00 inch) screws. Lower the transmission.
1. Lift and support the transmission, and install the 2 (5/16-18 x 3.00 inch) axle
horn screws, washers, and nuts (5/16-18 inch). Do not fully tighten the nuts
at this time.
2. Align the cross shaft and install the screw (0.375-16 x 2.00 inch) through the
transmission into the cross shaft. Do not tighten at this time.
g336198
Figure 103
3. Axle Horn Screws
Figure 104
Page 7–6 TITAN® Max Service Manual
3442-428 Rev A