Toro TITAN Max Service Manual page 46

Caster Assembly and Bearing Installation (continued)
Chassis: Service and Repairs
g342957
4. Apply anti-seize to fork shaft before installing.
5. Install the caster from the bottom side of the frame and place flat washer
on top of the bearing.
6. Install the (0.313-18NC x 0.750 inch) screw and tighten to the caster shaft.
Torque the screw to 22.597 ± 2.82 N • m (200 ± 25 in-lb).
g342955
7. Using a (32 mm) socket and a hammer, install the grease cap onto the frame.
Note: Replace the grease cap if damaged.
8. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
9. Lower the unit and verify proper function.
Figure 22
Figure 23
Page 5–10 TITAN® Max Service Manual
3442-428 Rev A