Table of Contents
Advertisement
Cabling Switches with SFP+ Modules
You can use any Allied Telesis 10G SFP+ module to connect the switches
in a stack.
Note
You must use a verified Allied Telesis TwinAx cable or SFP+ module
to configure switches in a VCStack. Cables and modules from other
vendors are not supported and will fail to create an active link.
For guidelines on cabling switches, refer to "Planning a Stack" on page 51.
To cable switches with fiber optic transceivers, perform the following
procedure:
1. Remove the dust cover from either the S1 or S2 slot on the switch.
2. To install the transceiver in the S1 slot, position it with the handle on
top, as shown in Figure 61. To install it in the S2 slot, position it with
the handle on the bottom.
Handle
Figure 61. Handle on SFP+ Module
3. Slide the module into the slot until it clicks into place, as shown in
Figure 62.
AT-IE510-28GSX Installation Guide
101
Advertisement
Table of Contents
