Cabling Switches With At-Stackxs/1.0 Transceivers; Figure 49: Removing The Dust Plug From The S1 Slot - Allied Telesis AT-x510-28GTX Installation Manual
X510 series gigabit ethernet switches
Hide thumbs
Also See for AT-x510-28GTX:
- Command reference manual (2601 pages) ,
- Installation manual (108 pages) ,
- Product information (8 pages)
Table of Contents
Advertisement
Chapter 6: Cabling the Stacking Ports
Cabling Switches with AT-StackXS/1.0 Transceivers
92
To cable the switches of the stack with AT-StackXS/1.0 transceivers,
perform the following procedure:
Warning
A transceiver can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
device.
1. Remove the dust plug from the S1 slot on the top switch of the stack,
as shown in Figure 49.
Figure 49. Removing the Dust Plug from the S1 Slot
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. Remove the dust cap from one end of the transceiver, as shown in
Figure 50 on page 93.
Advertisement
Table of Contents
