E-Mu ESI-32 Operation Manual page 98

Tip: The cursor buttons can be used to
go back to the previous field.
90
ESI-32 Operation Manual
or by typing the digit (1-7) directly using the keypad. The default
choice, "Search", instructs the ESI-32 to search for the first Emax II
device in the SCSI chain. Normally you will always use "Search" unless
you want to select a specific Emax II device out of several on the SCSI
bus. Press ENTER to confirm your choice and return to the option select
screen.
5. Press 1 to select the Import Options screen. The following screen
will appear. When this function is set to YES, the ESI-32 will issue
an extra prompt whenever a load operation is about to destroy the
current bank. Press ENTER after selecting your choice.
Confirm new bank: Y/N
6. Press 2 to select the Emax II Load screen. Immediately after Load
is selected, the ESI-32 will attempt to read and verify the Emax II
disk using Search mode or using the SCSI ID selected in the SCSI
Setup screen.
Emax-II LOAD from
B01 Bosendorf8M
If an Emax II disk cannot be found, an error message will be generated
indicating: "No Emax Drive Found".
7. Use the inc/dec buttons or the data entry control to select the
bank to load. When the correct bank is displayed, press ENTER.
The following screen will appear:
Emax-II LOAD from
B01 Bosendorf8M
*** ALL PRESETS ***
8. Press ENTER to select All Presets in the bank or use the inc/dec
buttons or the data entry control to select a specific preset.
Another option is "All Samples" which will only load the samples.
Press ENTER. The "Overwrite Bank" warning only appears if "All
Presets" or "All Samples" was selected (and "Confirm New Bank" was
enabled). If a specific preset was chosen the warning will not appear
and the preset (and associated samples) will be merged with the
current bank.
Emax-II IMPORT
Select Bank
Select Preset