E-Mu ESI-32 Operation Manual page 173

!
Caution: If the source zone contains no
secondary samples and you select both,
loading the zone will overwrite both primary
and secondary samples in the destination
preset.
7. Select whether you will load the primary, secondary, or both
samples from the zone, then press ENTER.
LOAD ZONE from
P00 both
Select pri/sec/both
8. Select the lowest key of the zone to be loaded, then press
ENTER. The default is to the lowest note of the lowest sample. You
can select a different low key in two ways. The data entry control
scrolls through the lowest key of each sample on the keyboard. The
data entry control is the fastest selection method if you want the
lowest key of the zone to coincide with the lowest note of a sample.
Or, you can use the keyboard to specify any note as the lowest note
of the zone.
LOAD ZONE from
P00 both C1
Select Low Key
The second line shows the note being played on the keyboard (or
scrolled with the data entry control). After selecting a note, the third line
displays the primary sample number, and the fourth line displays the
secondary sample number associated with the note on line two.
9. Select the highest key of the zone to be loaded, then press
ENTER. The default is to the highest note of the sample that con-
tains the previously specified low note. You can select a different
high key in two ways. The data entry control scrolls through the
highest key of each sample on the keyboard. The data entry control
is the fastest selection method if you want the highest key of the
zone to coincide with the highest note of a sample. Or, you can use
the keyboard to specify any note as the highest note of the zone.
LOAD ZONE from
P00 both C1 to C2
Select High Key
The second line shows the note being played on the keyboard (or
scrolled with the data entry control). After selecting a note, the third line
displays the primary sample number, and the fourth line displays the
secondary sample number associated with the note on line two.
165
Preset Definition