Error Codes - E-Mu ESI-32 Operation Manual

Error Codes

Tip: If the Error Code has the word
"Zero" anywhere in it, use the "Fix Samples"
utility to repair it.
212
ESI-32 Operation Manual
This section explains some of the error codes you might possibly
encounter while working with the ESI-32. This listing covers only the
error codes whose meaning might be confusing or unclear. Most of the
error codes explanations in the ESI-32 are readily apparent.
Drive Not Formatted!
Trying to access a hard drive that has not been formatted for the ESI-32.
FD Data Lost Error!
Bad disk or floppy drive.
FD Data CRC Error!
Bad disk or floppy drive.
FD Data Save Error!
Bad disk or floppy drive.
Floppy Disk Error!
Bad disk or floppy drive.
Floppy Seek Error!
Bad disk or floppy drive.
Insert Unlocked FD!
Floppy disk is locked.
Loop Start (End) Zero!
Sample header is corrupted and needs to be repaired using the
"Fix Samples" function.
Mono Start (End) Zero!
Sample header is corrupted and needs to be repaired using the
"Fix Samples" function.
No Samples in Preset!
No samples mapped to any zones.
No Samples Exist!
No samples in bank.
No Presets Exist!
No presets in bank.
No Valid Drives!
1) Conflicting SCSI devices. 2) No SCSI termination at each SCSI cable
end. 3) SCSI cable too long. 4) Reboot entire system after changing SCSI
cables or ID numbers.