Rename Sample - E-Mu ESI-32 Operation Manual

2. Rename
Sample
Tip: Use the data entry knob or
increment/decrement buttons to access the
full character set. Most keyboards do not
have enough keys to access all available
characters.
See the character chart on page 208 for a
complete listing of characters.
96
ESI-32 Operation Manual
6. Select the sample to be loaded, then press ENTER. As you scroll
through the samples, the display shows the names of the existing
samples, whether stereo or mono, sampling rate, and sample length.
LOAD SAMPLE from
001 Current Sample
Stereo
7. Select the destination sample number into which the source
sample will be loaded, then press ENTER. If you try to overwrite
an existing sample, you will be asked if you do want to overwrite.
Enter Yes to replace the existing sample, No to cancel the operation.
LOAD SAMPLE into
001 Selected Sample
000 Empty Sample
Select Dest Sample
8. If desired, rename the sample. Choose the characters to be
changed with the left and right cursor buttons. Select the desired
characters by using the ten key pad, data entry control and key-
board. You can also use the up cursor to insert spaces and the down
cursor to delete spaces. (See Sample Management, 2. Rename
Sample.)
9. Press ENTER to exit the submodule. The ESI-32 will return to the
Module Identifier.
This submodule allows you to rename any sample.
1. Activate Sample Management module.
2. Select Submodule 2.
3. Scroll through the samples available for renaming, then press
ENTER.
001 Current Sample
4. Rename the sample. Choose the characters to be changed with the
right and left cursor buttons. Select the desired characters by using
the ten key pad, data entry control and keyboard. You can also use
the up cursor to insert spaces and the down cursor to delete spaces.
44100Hz
3.0secs

RENAME SAMPLE

Select a Sample