Place Sample - E-Mu ESI-32 Operation Manual

6. Place
Sample
Tip: Preset "templates" may be created
by placing empty samples and assigning
dynamic processing parameters to keyboard
locations and then saving the bank.
To use the template, simply load or copy new
samples into the empty locations.
Samples in the bank can be placed to cover a particular range of the
keyboard.
1. Activate Sample Management module. The display will show the
current sample number and name. If this is not the sample you want
to place, refer to Sample Management, 0. Select Sample.
2. Select Submodule 6.
3. Select whether you want to place the sample to a primary or
secondary zone, then press ENTER.
pri
4. Select the original pitch of the sample, then press ENTER. As
you select notes, the display will show the samples mapped into the
preset.
pri G1
Select Original Key
5. Select the lowest key of the sample range, then press ENTER.
The display will indicate the preset status (described in step four).
pri G1 C1
6. Select the highest key of the sample range, then press ENTER.
The display will indicate the preset status (as described in step four).
pri G1 C1 to B1
7. If the display asks Overwrite Zone? Press Yes to overwrite, or
No to return to the Module Identifier. If you press Yes to over-
write, any previously assigned samples that fall within the just-
specified keyboard zone will be de-assigned from that zone.

PLACE SAMPLE

Select pri/sec
PLACE SAMPLE
PLACE SAMPLE
Select Low Key
PLACE SAMPLE
Select High Key
101
Sample Management