Table of Contents
Advertisement
216
ESI-32 Operation Manual
Problem:
Controllers (wheels, pedal, pressure) do not work at all
and are assigned correctly.
Cause:
Controllers are disabled in Realtime Control Enable
section.
Solution: Enable realtime controllers for the selected zone
(Dynamic Processing, 8. Realtime Control Enable).
Problem:
The footpedal or LFO has little or no effect when
assigned to VCA.
Cause:
The initial VCA level is set at 100%.
Solution: Lower the initial VCA setting as desired.
MIDI Problems
Since MIDI setups can be quite complex, make sure that you have all the
MIDI parameters (on the ESI-32 and external MIDI devices) set correctly
before you become daunted. On the ESI-32, MIDI parameters are
located in the Master/Global module, (9. MIDI, 2. MIDI Globals).
Problem:
The ESI-32 does not respond to the MIDI parameters as
programmed.
Cause:
MIDI Globals are turned off.
Solution: Turn on MIDI Globals (Master/Global, 9. MIDI, 2. MIDI
Globals).
Problem:
The ESI-32 does not respond to the modulation wheels
or pressure from an external MIDI controller.
Cause:
MIDI controllers are not assigned in the MIDI Globals or
Realtime Control submodules.
Solution: Assign proper controller channel numbers to Left
Wheel, Right Wheel, Pedal, Pressure, MIDI A and B,
then assign MIDI A and B to desired destinations
(Master/Global, 9. MIDI, 2. MIDI Globals). Check
Realtime Control routings (Preset Definition, 0. Realtime
Controls).
Hard Disk Problems
Problem:
The ESI-32 does not recognize an external hard disk or
other SCSI device.
Cause:
The external hard disk or SCSI device was powered-up
after the ESI-32.
Solution: Mount the drives using the Mount Drive function
located under Disk Utilities, 1 in the Master/Global
module.
Advertisement
Table of Contents
