Table of Contents
Advertisement
82
ESI-32 Operation Manual
5. MIDI Volume/Pan
When this function is turned On, the MIDI continuous controllers 7 and
10 will automatically be routed to volume and pan whenever the ESI-32
is in multimode (Volume and Pan are the standard functions of control-
ler number 7 & 10.) and their assignments in the Preset Definition
submodule will be ignored. When not in multimode, MIDI controllers 7
and 10 function as programmed in the Preset Definition submodule.
When MIDI Volume/Pan is turned Off, volume and pan must be pro-
grammed for each preset in the Preset Definition MIDI submodule.
1. Activate Master/Global module.
2. Select 9. MIDI, 5. Volume/Pan (9/5)
MIDI VOLUME/PAN
Route MIDI volume &
pan to MIDI Mix in
multimode?
3. Select whether or not you want the ESI-32 to automatically
respond to the volume and pan MIDI controllers (7 & 10) when
in multimode.
4. Press ENTER to exit the submodule. The changes will be stored
and the ESI-32 will return to the Module Identifier.
6. Multimode Enable
Multimode Enable consists of two functions. "Boot in Multi" automati-
cally turns multimode on whenever the unit is powered up. When "Use
Bank State" is enabled (yes), the state of Multimode (on or off) will be
saved along with the bank. Therefore, if multimode was on when the
bank was saved, it will be turned on when the bank is loaded.
1. Activate Master/Global module.
2. Select 9. MIDI, 6. Multimode Enable (9/6)
MULTIMODE ENABLE
Boot in Multi:
Use Bank State:
3. Select whether or not you want Multimode to be global or bank
dependent, then press ENTER
4. Press ENTER to exit the submodule. The changes will be stored
and the ESI-32 will return to the Module Identifier.
yes
yes
yes
Advertisement
Table of Contents
