Table of Contents
Advertisement
!
Caution: Dangerous voltages are present
inside the ESI-32 enclosure. Consult your
local E-mu dealer or call E-mu customer
service for information about updating RAM.
5. Select the mode for each trigger button. Mode "On" plays a key
whenever the button is pressed. "Latch" mode holds the key on until
the button is pressed again.
6. Press ENTER to exit the submodule. The ESI-32 will return you
to the Module Identifier.
8. RAM Test
RAM is an acronym for Random Access Memory. RAM is used to store
presets and samples in the ESI-32's bank. There is also another block of
RAM used by the ESI-32's main computer. This function allows you to
test the memory by first filling it with numbers and then reading them
back.
A RAM test should always be performed after you have updated the
amount of sample memory in your ESI-32. The test will verify if the new
RAM is working and has been correctly installed.
1. Activate Master/Global module.
2. Select 8. Special, 8. Ram Test (8/8). The following screen will
appear.
Clears Sample Memory
3. Press Yes to begin the test. Press No, Exit, or Enter to return to
the Submodule Indentifier.
4. If you pressed Yes, the CPU RAM test will begin and the amount of
RAM in the machine will be displayed. Allow the CPU RAM test to
run through several cycles (C: = cycles). Press ENTER to proceed
to the sample RAM test.
5. The Sound RAM Fixed Test will begin. After four cycles, the Random
test will begin. Allow the test to run completely through several
cycles. Press ENTER to stop the test. Any memory errors will be
displayed.
6. Press ENTER again to exit the submodule. The ESI-32 will return
you to the Submodule Identifier.
RAM TEST
WARNING
Proceed? Y/N
75
Master/Global
Advertisement
Table of Contents
