Table of Contents
Advertisement
4. Copy
Zone
!
Caution: If the source zone contains no
secondary samples and you select both,
loading the zone will overwrite both primary
and secondary samples in the destination
preset.
The second line shows the note being played on the keyboard (or
scrolled with the data entry control). After selecting a note, the third line
will display the primary sample number, and the fourth line displays the
secondary sample number associated with the note on line two.
6. Press Yes to erase the zone, or No to cancel the operation. In
either case, you will return to the Module Identifier.
This submodule allows zones to be copied into any preset.
1. Activate Preset Definition module.
2. Select Submodule 4.
3. Select the preset that contains the zone to be copied, then press
ENTER.
P00 Current Preset
Select Source Preset
4. Select whether you will copy the primary, secondary, or both
samples from the zone, then press ENTER.
P00 both
Select pri/sec/both
P00 both C1
Select Low Key
Primary Samples
Sample 05
Secondary Samples
Sample 01
= Copied Zone
Fc
Vel -> Level
Tuning
Pan
A copied zone consists of all Samples and Dynamic Processing parameters contained in that zone.
COPY ZONE from
COPY ZONE from
COPY ZONE from
Sample 06
Sample 07
Sample 02
Sample 03
Sample 08
Sample 04
171
Preset Definition
Advertisement
Table of Contents
