Erase Zone - E-Mu ESI-32 Operation Manual

3. Erase
Zone
170
ESI-32 Operation Manual
Use this function to erase a zone.
1. Activate Preset Definition module.
2. Select Submodule 3.
3. If there are both primary and secondary samples, select the one
you want to edit, then press ENTER. If there are only primary or
only secondary samples, the ESI-32 will automatically proceed to
step 4.
P00 pri
Select pri/sec/both
4. Select the lowest note of the zone to be erased, then press
ENTER. The default is to the lowest note of the lowest sample. You
can select a different low key in two ways. The data entry control
scrolls through the lowest key of each sample on the keyboard. The
data entry control is the fastest selection method if you want the
lowest key of the zone to coincide with the lowest note of a sample.
Or, you can use the keyboard to specify any note as the lowest note
of the zone.
P00 both C1
Select Low Key
The second line shows the note being played on the keyboard (or
scrolled with the data entry control). After selecting a note, the third line
displays the primary sample number, and the fourth line displays the
secondary sample number associated with the note on line two.
5. Use the data entry control to select the highest note of the zone
to be erased, then press ENTER. The default is to the highest note
of the sample that contains the previously specified low note. You
can select a different high key in two ways. The data entry control
scrolls through the highest key of each sample on the keyboard.
(The data entry control is the fastest selection method if you want
the highest key of the zone to coincide with the highest note of a
sample.) Or, you can use the keyboard to specify any note as the
highest note of the zone.
P00 both C1 to C2
Select High Key

ERASE ZONE

ERASE ZONE

ERASE ZONE