E-Mu ESI-32 Operation Manual page 180

172
ESI-32 Operation Manual
5. Select the lowest key of the zone to be copied, then press
ENTER. The default is to the lowest note of the lowest sample. You
can select a different low key in two ways. The data entry control
scrolls through the lowest key of each sample on the keyboard. (The
data entry control is the fastest selection method if you want the
lowest key of the zone to coincide with the lowest note of a sample.)
Or, you can use the keyboard to specify any note as the lowest note
of the zone.
The second line shows the note being played on the keyboard (or
scrolled with the data entry control). After selecting a note, the third line
will display the primary sample number, and the fourth line will display
the secondary sample number associated with the note on line two.
6. Select the highest key of the zone to be copied, then press
ENTER. The default is to the highest note of the sample that con-
tains the previously specified low note. You can select a different
high key in two ways. The data entry control scrolls through the
highest key of each sample on the keyboard. (The data entry control
is the fastest selection method if you want the highest key of the
zone to coincide with the highest note of a sample.) Or, you can use
the keyboard to specify any note as the highest note of the zone.
P00 both C1 to C2
Select High Key
The second line shows the note being played on the keyboard (or
scrolled with the data entry control). After selecting a note, the third line
will display the primary sample number, and the fourth line will display
the secondary sample number associated with the note on line two.
7. Select the preset into which the zone will be copied, then press
ENTER. The ESI-32 will default to the lowest numbered empty
preset.
P01 Empty Preset
Select Dest Preset
If you select an empty preset, upon pressing ENTER you will be given a
chance to rename the preset that the ESI-32 just created for you. Choose
the characters to be changed with the left and right cursor buttons.
Select the desired characters by using the ten key pad, data entry con-
trol, and/or keyboard. You can also use the up cursor to insert spaces
and the down cursor to delete spaces. After renaming is complete, press
ENTER.
COPY ZONE from
COPY ZONE into