Table of Contents
Advertisement
4. Select the highest key of the zone to be crossfaded or switched,
then press ENTER. The ESI-32 defaults to the highest note of the
sample that contains the previously specified low note. You can
select a different high key in two ways. The data entry control scrolls
through the highest key of each sample on the keyboard. The data
entry control is the fastest selection method if you want the highest
key of the zone to coincide with the highest note of a sample. Or,
you can use the keyboard to specify any note as the highest note of
the zone.
CROSSFADE/SWITCH
P00
Select High Key
The second line shows the note being played on the keyboard (or
scrolled with the data entry control). After selecting a note, the first line
displays the zone' s crossfade status, the third line displays the primary
sample number, and the fourth line displays the secondary sample
number associated with the note on line two.
5. Select the desired type of crossfade from the following choices,
then press ENTER.
CROSSFADE/SWITCH
P00
Crossfade Off
Select a Crossfade
•
Crossfade Off: There is no crossfading between the primary and
secondary samples.
•
Velocity Crossfade: One sample will become louder as you play
more forcefully; the other sample will become softer.
•
Velocity Switch: If you strike a key with more force than the mid-
point of the velocity range, one sample will play. If you strike a key
with less force than the mid-point of the velocity range, the other
sample will play.
•
Positional Crossfade: As you play from low to high over the
selected zone, one sample will fade out as the other sample fades in.
This is a useful technique for maintaining an even tone quality over
the keyboard when multi-sampling.
•
Realtime Crossfade: Crossfading occurs not according to keyboard
velocity, but according to the realtime controller that has been
assigned in Preset Definition, 0. Realtime Controls.
•
Realtime Switch: Switching occurs not according to keyboard
velocity, but according to the realtime footswitch values set in Preset
Definition, 0. Realtime Controls.
C1 to C2
C1 to C2
Preset Definition
175
Advertisement
Table of Contents
