Prompts - EDAN iM3 User Manual

Vital Signs Monitor User Manual
Message
Network Disconnect
Network Traffic
Abnormity

9.3 Prompts

Message
SpO Search Pulse
2
SpO Noisy Signal
2
Manual Measuring
Continual Measuring
Cause
In distributed
system, the monitor's
network is disconnected.
Abnormal network traffic
has been detected. The
data traffic exceeds the
limit.
Cause
SpO module is analyzing the patient signal and searching
2
for the pulse to compute the saturation, when sensor is
connected with patient.
There is interference with SpO
to patient movement, ambient light, electrical interference
or else. (Nellcor SpO
In manual measuring mode
In continuous measuring mode
- 64 -
Alarm Level
alarm
Low
High
2
)
2
Alarm Information
Action Taken
1) Check if the
network cable
well connected.
2) Check if the
MFM-CMS
turned on.
3) Check if the IP
of bedside monitor
and MFM-CMS are
on the
network segment.
4) Contact
professionals
authorized
manufacturer
check the network
problem.
Disconnect
network to make
the monitor work
properly, and then
contact
professionals
authorized
manufacturer
check the network
problem.
measurement signals due
is
is
same
the
by
to
the
the
by
to