Table of Contents
Advertisement
Vital Signs Monitor User Manual
Chapter 17 Recording
A thermal dot matrix recorder is used for the monitor and can support many recording types and
output patient information, measurement data, review data waveform and so forth.
1
3
4
1
2
3
4
17.1 Performance of the Recorder
Waveform record is printed at the rate of 12.5 mm/s, 25 mm/s or 50 mm/s; default setting is
25 mm/s.
49 mm ~ 50 mm wide printout paper.
Record one SpO
User-selectable real-time recording time and waveform.
Auto recording interval is set by the user, and the waveform is in accordance with the real
time recording.
NOTE:
It is suggested that the user should not use the recorder when the low battery displays, or
the monitor may be turned off automatically.
17.2 Starting and Stopping Recording
The monitor provides several types of stripe recording. You can start recording following the
procedure below:
Recording indicator
Paper feeding key: press this key to start or stop feeding
recording paper without outputting anything on the paper
Paper outlet
Recorder door
waveform; default setting is off.
2
2
4
- 109 -
Recording
Advertisement
Table of Contents
