Timecode Generator Ltc 1, 2, 3 - FOR-A FA-9600 Operation Manual

5-30. TIMECODE GENERATOR LTC 1, 2, 3

This menu allows you to generate LTC timecodes. To embed timecode onto FS output, set H ANC
to Overwrite (Sec. 5-26. "ANCILLARY MULTIPLEX") and ATC(LTC) to Enable (Sec. 5-29. "TIME
CODE MULTIPLEX").
Item Default
Start/
-
Stop
Adjust 0
- -
- -
Source ATC(LTC)
Loss
Stay
Mode
Drop Non-Drop
Frame Frame
Preset
HH:MM: 00:00:00:00
SS:FF
Setting
Pressing F1 Unity button starts the timecode.
-
Re-pressing the button stops the timecode.
Sets the offset from the source timecode.
-16 to +16
To delay the timecode, use a negative number.
- Pressing F3 Unity resets the timecode.
Pressing F4 Unity sets the timecode to the
-
preset set value.
Selects the timecode source. (See next page.)
ATC(LTC)
ATC(LTC): ATC(LTC) timecode in the SDI input
ATC(VITC)
A(VITC): ATC(VITC) timecode in the SDI input
VITC(DVITC)
VITC(DVITC): VITC(DVITC) timecode in the SD-
SDI input
LTC IN
LTC IN: LTC input (FA-96DIN4- -CBL required)
Generator
Generator: Generator's timecode
Selects the way to recover when a timecode
source loss is detected.
Stay
Stay: Stays outputting the last timecode.
Continue
Continue: Continues running with the timing
before loss and keeps the continuity.
Output Disable
Output Disable: Stops timecode output when
the source loss is detected.
Selects drop frame or non-drop frame timecode.
Non-Drop Frame
Drop Frame is available only for 29.97/30Hz
Drop Frame
signals.
Sets the timecode preset value.
00:00:00:00 to
Pressing F4 Unity sets this value to the
23:59:59:29
timecode.
71
Simultaneous 4K/HD
Dual HD
3D-LUT (FS1)
Description