Table 38: Alarm Status; Table 39: Signal Quality (From At Reference Guide By Telit) - WAGO -TO-PASS 761 Manual

90 Value Script FW 2.20 (Standard)
The counter status shows the last change that has occurred since the last value
script transmission, or after a system start (independent of the SMS and logger
status).
The counter values are indicated as hexadecimal values (as are the MODBUS
values).
Alarms can have the following statuses:

Table 38: Alarm status

Status Explanation
0
1
2
If both values are reached simultaneously, only status "2" is transmitted.
&SQ: Signal quality or modem connection (without formatting):

Table 39: Signal quality (from AT Reference Guide by Telit)

Value
0
1
2 ... 30 (-109)dBm ... (-53)dBm / 2 dBm per stage
31
99
&MV: Transmission is performed only up to the last configured register (module
address not 0).
If registers were not previously parameterized (module address = 0), these will be
marked as "ZERO".
If errors occurred during register querying, these will be flagged with "ERRO".
No alarm
First value reached/transgressed
Second value reached/transgressed
Quality
(-113) dBm or less
(-111) dBm
(-51)dBm or greater
Unknown or cannot be measured
WAGO-TO-PASS® 761
761-112 Telecontrol Module Compact, Web
Manual
Version 2.0.0