Dräger Fabius plus Instructions For Use Manual page 202

Technical data
Measured value or
waveform
Note: If the end-tidal desflurane concentration increases to above 12%, the measurement accuracy of
the tidal volume and minute volume can deviate by more than 15%.
Freq Respiratory rate
FiO O measurement
2 2
in the mainstream
1) Max. ±4 % of the measured value or ±2 cmH
2) With standard test conditions in accordance with ISO 80601-2-13.
O sensor
2
Response time (T90)
Heat-up time
Drift sensitivity
Cross sensitivity
Measurement deviation due to
humidity
Maximum period of use of O
sensor cell
202
Range Resolution Accuracy
2 to 99 bpm ±1 bpm
(1/min) (1/min)
10 to 100 Vol% 1 Vol%
O (±2 hPa), depending on which value is higher.
2
Less than 16 seconds
after 5 minutes
Max. ±0.02% of the measured value per % relative humidity
>12 months at 25 °C (77 °F), 50 % relative humidity, 50 % O
2
gas (or >5000 hours at 100 Vol% O
±1 bpm (±1 1/min) of
the setting or ±5%,
depending on which
value is higher
±2.5 Vol% +2.5 % of
the measured values in
accordance with
ISO 21647 and
ISO 80601-2-55
Measured values are not pressure
compensated.
Error with ≤ 3% of the measured value
±1 % of the measured value/ 8 h
1 Vol% O at 70 Vol% N
2
CO
2
With 4 Vol% halothane
or with 5 Vol% enflurane
or with 15 Vol% desflurane
or with 5 Vol% isoflurane
or with 10 Vol% sevoflurane
)
2
Instructions for use Fabius plus SW 3.n
Condition
Based on the
ambient pressure
during calibration
O and 5 Vol%
2
in fresh
2