Changing The Alarm Volume - Dräger Fabius plus Instructions For Use Manual

Configuration

Changing the alarm volume

WARNING
Risk of not hearing the alarm tone
When operating in a loud environment, the
acoustic alarm signals may not be heard.
Always set the alarm tone to a sufficient
volume.
Volume Control
1 Press the AccessAlarm Volume softkey (A).
Volume Control
2 Set the new alarm volume to a value between 1
(minimum) and 10 (maximum) and confirm.
152
The lower value is limited by the setting in the
standby configuration (see chapter ''Changing the
minimum alarm volume'' on page 141).
The pressure waveform and softkeys are
displayed again.
A
Instructions for use Fabius plus SW 3.n