Installing The Cable Management Arm (Optional) - Cisco UCS C4200 Installation And Service Manual

Installing the Cable Management Arm (Optional)

With the server fully pushed into the slide rails, open a hinged slam latch lever on the front of the server and insert a
screw through the hole that is under the lever. The screw threads into the static part of the rail on the rack post and prevents
the server from being pulled out. Repeat for the opposite slam latch.
Installing the Cable Management Arm (Optional)
Note The cable management arm (CMA) is reversible left-to-right. To reverse the CMA, see
Management Arm (Optional), on page 15
Step 1
With the server pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from the server onto the
end of the stationary slide rail that is attached to the rack post. Slide the tab over the end of the rail until it clicks and
locks.
Figure 7: Attaching the CMA to the Rear Ends of the Slide Rails
1 CMA tab on arm farthest from server attaches
to end of stationary outer slide rail.
2 CMA tab on arm closest to the server attaches
to end of inner slide rail attached to server.
Cisco UCS C4200 Server Chassis Installation and Service Guide
14
before installation.
3 CMA tab on width-adjustment slider attaches
to end of stationary outer slide rail.
4 Rear of server
Installation and Initial Setup
Reversing the Cable